TM 5-3825-230-14&P
(b)
Install two O-rings (36) on valve spool (35), and install spool.
(c)
Install detent sleeve (34) in detent sleeve housing (30) aligning groove in detent sleeve with hole in
top of detent sleeve housing.
(d)
Install steel ball (33) and spring (32) in hole and install detent plug (31) using a 5/8 in. open end
wrench.
WARNING
• Adhesives, solvents and sealing compounds can burn easily, can give off harmful vapors and are
harmful to skin and clothing. To avoid injury or death, keep away from open fire and use in a well-
ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash
immediately with soap and water.
• Spring is under extreme pressure and may come out with velocity. Use extreme caution and wear
eye protection.
(e)
Apply thread sealing compound to lockwasher (29) and install lockwasher, spring (28), stopcollar
(27), washer (26), and screw (25) on valve spool (35).
5-107
