TM 5-3825-230-14&P
f. Pump Inlet Hose Replacement.
(1)
Removal.
(a)
Remove clamp (1) and hose (2) using a flat tip screwdriver.
(b)
Remove O-ring (3) from fitting (4).
(c)
Remove fitting (4) using a 1-5/8 in. open end wrench.
(d)
Remove clamp (5) from hose (2).
(e)
Remove bead insert (6) using a 1-3/8 in. open end wrench.
(f)
Remove reducer bushing (7) using a 1-13/16 in. open end wrench and elbow(8) using a pipe wrench.
(2)
Installation .
Adhesives, solvents, and sealing compounds can burn easily, can give off
harmful vapors, and are harmful to skin and clothing. To avoid injury or death,
keep away from open fire and use in a well-ventilated area. If adhesive, solvent, or
sealing compound gets on skin or clothing, wash immediately with soap and
water.
(a)
Apply thread sealing compound to threads of elbow (8).
(b)
Install reducer bushing (7), using a 1-13/16 in. open end wrench and elbow (8) using a pipe wrench.
(c)
Install bead insert (6) using a 1-3/8 in. open end wrench.
(d)
Install hose (2) on bead insert (6) using clamp (5). Tighten using a flat tip screwdriver.
(e)
Install fitting (4) using a 1-5/8 in. open end wrench.
(f)
Install O-ring (3) on fitting (4).
(g)
Install hose (2) on fitting (4) using clamp (1). Tighten using a flat tip screwdriver.
4-191
