TM 5-3825-230-14&P
b.
Rear Wheel.
WARNING
If wheel must be changed during
travel, set out markers to avoid an
accident.
NOTE
This procedure is the same for both
left and right rear tires.
(1)
Removal.
(a)
Loosen five lug nuts (1) slightly using
a breaker bar, extension and 13/16 in.
socket.
WARNING
Do not work on any item supported
only by lift jacks or hoist. Always
use blocks or proper stands to
support the item prior to any work.
Equipment may fall and cause injury
or death to personnel.
NOTE
Do not raise sweeper any higher than needed to remove wheel off hub.
(b)
Raise side of sweeper with bad wheel using a jack positioned under rear lifting eye. Install jack stands.
(c)
Remove five lug nuts (1), and wheel (2) from hub (3).
(2)
Installation.
(a)
Position wheel (2) on hub (3), and install five lug nuts (1) using a breaker bar, extension and 13/16 in.
socket.
(b)
Remove jackstands and slowly lower and remove jack.
(c)
Tighten lug nuts to 80 lb-ft (108 N.m) using a torque wrench and 13/16 in. socket in pattern shown.
(d)
If used, stow markers.
END OF TASK
4-153
