TM 5-3825-230-14&P
4-88. WHEEL REPLACEMENT.
This task covers:
a.
Front Wheel
b.
Rear Wheel
INITIAL SETUP
Tools
General Safety Instructions
Tool Kit, General Mechanic's: Automotive
Sweeper on level ground, wheels blocked, hand
brake set.
Shop Equipment, Automotive Maintenance and
Repair; Organizational Maintenance, Common
No. 1, Less Power
Lifting device with chains
Jack stands
a.
Front Wheel
WARNING
If wheel must be changed during
travel, set out markers to avoid an
accident.
(1)
Removal.
(a)
Loosen five lug nuts (1) slightly using
a breaker bar, extension and 13/16 in.
socket.
NOTE
Do not raise sweeper any higher than
needed to remove wheel off hub.
(b)
Raise front of sweeper using a suitable
lifting device with chains attached to
front lifting eye/tie down point.
(c)
Remove five lug nuts (1), and wheel
(2) from hub (3).
(2)
Installation.
(a)
Position wheel (2) on hub (3), and install five lug nuts (1) using a breaker bar, extension and 13/16 in.
socket.
(b)
Slowly lower and remove lifting device and chains.
(c)
Tighten lug nuts to 80 lb-ft (108 N.m) using a torque wrench and 13/16 in. socket in pattern shown.
(d)
If used, stow markers.
4-152
