TM 5-3825-230-14&P
4-55. NOISE SHROUDS REPLACEMENT (CONT).
(2)
Install front shroud (1) as follows:
(a)
Install rubber seal (5) on front shroud (1).
(b)
Position front shroud (1) and install screw (3), and washer (4) using a 10 mm open end wrench.
(c)
Install two screws (2) using a cross tip off-set screwdriver.
b.
Fan Shroud.
(1)
Remove fan shroud (6) as follows:
(a)
Remove two screws (7), four washers (8), and two lockwashers (9) using a 17 mm open end wrench.
(b)
Remove screw (10) and lockwasher (11) using a 13 mm open end wrench.
(c)
Remove fan shroud (6).
(2)
Install fan shroud (6) as follows:
(a)
Position fan shroud (6) and install lockwasher (11), and screw (10) using a 13 mm open end wrench.
(b)
Install two lockwashers (9), two screws (7), and four washers (8) using a 17 mm open end wrench.
4-80
