TM 5-3805-296-23-4
0264
INSTALLATION CONTINUED
NOTE
Remove plugs and caps from hydraulic hoses and fittings.
Install hydraulic hoses as tagged and marked during removal.
59. Install pressure-reducing valve and plate assembly (Figure 53, Item 7) on machine.
60. Install three washers (Figure 53, Item 2) and nuts (Figure 53, Item 3) on pressure-reducing valve and plate
assembly (Figure 53, Item 7).
61. Install two washers (Figure 53, Item 6) and bolts (Figure 53, Item 5) on pressure-reducing valve and plate
assembly (Figure 53, Item 7).
62. Install new O-ring (Figure 53, Item 8) on fitting (Figure 53, Item 9).
63. Install line (Figure 53, Item 4) on pressure-reducing valve and plate assembly (Figure 53, Item 7) and tighten
tube nut (Figure 53, Item 1).
64. Install wiring harness (Figure 53, Item 12) and new tiedown strap (Figure 53, Item 10) on ladder clip
(Figure 53, Item 11).
65. Connect wiring harness connector (Figure 53, Item 13) to pressure-reducing valve (Figure 53, Item 14).
Figure 53. Rear of Transmission.
0264