TM 5-3805-296-23-2
0138
Table 1. One or More Park Lights Do Not Operate.
0138
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
NOTE
One or More Park Lights Do
Not Operate
Always inspect harness connectors that are involved in the circuit. Poor
connections can often be the cause of a problem in an electrical circuit.
Verify that all connections in the circuit are clean and secure and that all
connections are in good condition. If a problem with the connection is
found, correct the problem and verify that this malfunction or diagnostic
code is active before performing this procedure.
Perform open or short-circuit test at each harness connection to identify
the correct harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
Test Step 1. Verify Condition.
No Proceed to Test Step 2.
Were you directed here from All
Yes Proceed to Test Step 20.
Lights, Horn, and Backup Alarm
Fail To Operate (WP 0141).
Test Step 2. Test Operation of Park
Lights.
1. Turn battery disconnect switch to
ON position (TM 5-3805-296-10).
2. Turn mode switch on military light
switch to SER. DRIVE position
(TM 5-3805-296-10).
3. Observe park lights.
All Park Lights Do Not Operate
Proceed to Test Step 3.
Only Front Park Lights Do Not
Operate Proceed to Test Step 8.
Only Left Front Park Light Does Not
Operate Proceed to Test Step 11.
Only Right Front Park Light Does Not
Operate Proceed to Test Step 12.
Only Left Rear Park Light Does Not
Operate Proceed to Test Step 13.
Only Right Rear Park Light Does Not
Operate Proceed to Test Step 14.
Only Rear Park Lights Do Not
Operate Proceed to Test Step 15.
