TM 5-3805-296-23-2
0126
Table 1. Load Cylinder Rod Does Not Extend Fully.
0126
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Load Cylinder Rod Does Not
WARNING
Extend Fully
DO NOT disconnect or remove any hydraulic system hoses, tubes, or
fittings unless engine is shut down and hydraulic system pressure has
been relieved. Escaping hydraulic fluid under pressure can penetrate
skin.
At operating temperature, hydraulic oil is hot.
Wear protective eye covering and gloves when performing hydraulic
system testing.
Lubricating/hydraulic oils used in performance of maintenance can be
very slippery. Immediately wipe up any spills.
Failure to follow these warnings may result in injury or death to
personnel.
NOTE
Incorrect oil viscosity can be a factor in many different hydraulic system
symptoms.
Proceed directly to Test Step 2 if sent here by Implement, Cushion Hitch,
and Steering System Operation Test.
Test Step 1. Verify Malfunction is
Active.
Perform Implement, Cushion Hitch,
Cause of Malfunction Identified and
and Steering System Operation Test
Repaired During Testing
(WP 0172).
Troubleshooting complete.
Cause of Malfunction Not Identified
During Testing, Malfunction Active
Proceed to Test Step 2.
Test Step 2. Test Cushion-Hitch
Linkage Adjustment.
1. Adjust leveling system
linkage (WP 0405).
2. Verify correct operation of cushion
Load Cylinder Rod Extends Fully
hitch (TM 5-3805-296-10).
Troubleshooting complete.
Load Cylinder Rod Fails to Extend
Fully Proceed to Test Step 3.
