TM 5-3805-296-23-2
0125
Table 1. Response of All Implements Too Slow, Cushion Hitch Operates Normally Continued.
0125
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
7. Have assistant fully raise bowl and
Response of All Implements
Pressure Difference as Specified
hold joystick in raise position
Too Slow, Cushion Hitch
Have assistant lower bowl to ground
(TM 5-3805-296-10). Read and
Operates Normally
and release joystick
note pressure on both gauges
Continued
(TM 5-3805-296-10).
(Figure 4, Item 3) and (Figure 5,
Have assistant release throttle lock and
Item 3). Subtract lower pressure
return engine speed to idle
reading from higher pressure
(TM 5-3805-296-10).
reading. The difference must be
Have assistant turn ignition switch and
2190 75 psi (15,100 500 kPa).
battery disconnect switch to OFF
position (TM 5-3805-296-10).
Remove test equipment.
Proceed to Test Step 4.
Pressure Difference Not as Specified
Have assistant lower bowl to ground
and release joystick
(TM 5-3805-296-10).
Have assistant release throttle lock and
return engine speed to idle
(TM 5-3805-296-10).
Have assistant turn ignition switch and
battery disconnect switch to OFF
position (TM 5-3805-296-10).
Remove test equipment.
Replace main relief valve (WP 0433).
Proceed to Test Step 5.
Test Step 4. Perform Calibration.
1. Perform bowl lever sensor
Calibration Successful Proceed to
calibration (WP 0173).
step 2.
Calibration Unsuccessful, Fault
Code Active Diagnose and repair
fault code displayed on screen
(WP 0005).
Proceed to Test Step 6.
2. Perform ejector lever sensor
Calibration Successful Proceed to
calibration (WP 0173).
step 3.
Calibration Unsuccessful, Fault
Code Active Diagnose and repair
fault code displayed on screen
(WP 0005).
Proceed to Test Step 6.
3. Perform apron lever sensor
Calibration Successful Proceed to
calibration (WP 0173).
step 4.
Calibration Unsuccessful, Fault
Code Active Diagnose and repair
fault code displayed on screen
(WP 0005).
Proceed to Test Step 6.
0125-11
