TM 5-3805-296-23-2
0118
Table 1. Secondary Steering Indicator Always Illuminated Continued.
0118
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3. Using digital multimeter
Secondary Steering
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Indicator Always Illuminated
Proceed to Test Step 6.
between connector A-C1
Continued
Resistance Greater Than 5.0 Ohms
terminal 19 and terminal 20
Remove jumper wire from connector
(WP 0012, Figure 106).
M-C1 terminal 1 and terminal 2
(WP 0012, Figure 136).
Replace transmission wire harness
(WP 0266).
Proceed to Test Step 9.
Test Step 6. Test Chassis Wiring
Harness for High Resistance or
Open.
1. Remove jumper wire from
connector M-C1 terminal 1 and
terminal 2 (WP 0012, Figure 136).
2. Connect jumper wire between
connector J-C3 terminal 19 and
terminal 20 (WP 0012,
Figure 101).
3. Disconnect connector J-C8
(WP 0012, Figure 100) from
connector W-C1 (WP 0012,
Figure 99).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 7.
between connector J-C8
Resistance Greater Than 5.0 Ohms
terminal 54 and terminal 69
Remove jumper wire from connector
(WP 0012, Figure 100).
J-C3 terminal 19 and terminal 20
(WP 0012, Figure 101).
Replace chassis wire harness
(WP 0305).
Proceed to Test Step 9.
Test Step 7. Test Main Cab Wiring
Harness for High Resistance or
Open.
1. Remove jumper wire from
connector J-C3 terminal 19 and
terminal 20 (WP 0012,
Figure 101).
2. Remove upper and lower plenum
from ROPS (WP 0504).
3. Disconnect connector P-C1
(WP 0012, Figure 253) from
connector W-C7
(WP 0012, Figure 252).
0118-4