TM 5-3805-296-23-2
0118
Table 1. Secondary Steering Indicator Always Illuminated.
0118
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
NOTE
Secondary Steering
Indicator Always Illuminated
Always inspect harness connectors that are involved in the circuit. Poor
connections can often be the cause of a problem in an electrical circuit.
Verify that all connections in the circuit are clean and secure and that all
connections are in good condition. If a problem with the connection is
found, correct the problem and verify that this malfunction or diagnostic
code is active before performing this procedure.
Perform open or short-circuit test at each harness connection to identify
the correct harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
Test Step 1. Check For Active Codes.
1. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
2. At MSD, check for active
Diagnostic Code(s) Active
diagnostic code(s) (WP 0008).
Diagnose and repair active diagnostic
code(s) (WP 0005).
Proceed to Test Step 9.
No Diagnostic Code(s) Active
Proceed to step 4.
3. At MSD, check for active event
Event Code(s) Active Diagnose and
code(s) (WP 0008).
repair active event code(s) (WP 0005).
Proceed to Test Step 9.
No Event Code(s) Active Proceed to
Test Step 2.
Test Step 2. Check For Other Active
Malfunctions.
Are other steering system or
Yes Diagnose and repair steering
implement system malfunctions active. system and/or implement system
malfunction(s) (WP 0005).
No Proceed to Test Step 3.
Test Step 3. Test for Open Secondary
Steering Flow Switch.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector M-C1
(WP 0012, Figure 136) from
secondary steering flow switch
(WP 0012, Figure 135).
3. Connect jumper wire between
connector M-C1 terminal 1 and
terminal 2 (WP 0012, Figure 136).
