TM 5-3805-296-23-2
0104
Table 1. Engine Will Not Crank.
0104
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
NOTE
Engine WIll Not Crank
Always inspect harness connectors that are involved in the circuit. Poor
connections can often be the cause of a problem in an electrical circuit.
Verify that all connections in the circuit are clean and secure and that all
connections are in good condition. If a problem with the connection is
found, correct the problem and verify that this malfunction or diagnostic
code is active before performing this procedure.
Perform open or short-circuit test at each harness connection to identify
the correct harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
Test Step 1. Check for Active Event
Codes.
1. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
2. At MSD, check for active event
Event Code(s) Active Diagnose and
code(s) (WP 0008).
repair active event code(s) (WP 0005).
Proceed to Test Step 27.
No Event Code(s) Active Proceed to
Test Step 2.
Test Step 2. Check for Active
Diagnostic Codes.
At MSD, check for active diagnostic
Diagnostic Code(s) Active
code(s) (WP 0008).
Diagnose and repair active diagnostic
code(s) (WP 0005).
Proceed to Test Step 27.
No Active Diagnostic Codes
Proceed to Test Step 3.
Test Step 3. Test for Open Fuse F13.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Remove fuse F13 from circuit
breaker panel
(TM 5-3805-296-10).
Continuity Install fuse F13 on circuit
(WP 0540), measure resistance
breaker panel (TM 5-3805-296-10).
between terminals of fuse F13.
Proceed to Test Step 4.
No Continuity Discard fuse F13.
Proceed to Test Step 11.