TM 5-3805-296-23-2
0096
Table 1. 0263 Sensor Power Supply Diagnostic Codes - Continued.
0096
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
7. Using digital multimeter
0263-03 Digital Sensor
Continuity Replace dash wiring
(WP 0540), test for continuity
Power Supply (8V or 12V)
harness (WP 0510).
between connector P-C18
Voltage Above Normal
Proceed to Test Step 4.
terminal 24 (WP 0012, Figure 269)
Continued
No Continuity Replace tractor
and all other terminals in
operator monitor (WP 0506).
connector P-C18 (WP 0012,
Proceed to Test Step 4.
Figure 269).
Test Step 4. Verify Malfunction is
Resolved.
1. Ensure all harness connectors are
connected.
2. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
3. At MSD, check for active
263-3 Digital Sensor Power Supply
diagnostic codes (WP 0008).
(8V or 12V) Voltage Above Normal
Becomes Inactive Proceed to step 4.
263-3 Digital Sensor Power Supply
(8V or 12V) Voltage Above Normal
Remains Active Repeat
troubleshooting from the beginning.
4. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
5. If removed, install instrument panel
(Figure 2, Item 3) with six bolts
(Figure 2, Item 4) on ROPS
(Figure 2, Item 5).
6. If removed, install right vent
(Figure 2, Item 7) with two bolts
(Figure 2, Item 6) on instrument
panel (Figure 2, Item 3).
7. If removed, install left vent
(Figure 2, Item 2) with two bolts
(Figure 2, Item 1) on instrument
panel (Figure 2, Item 3).
8. If removed, install instrument panel
cover (Figure 1, Item 3) with six
washers (Figure 1, Item 2) and
bolts (Figure 1, Item 1) on ROPS
(Figure 1, Item 4).
9. If removed, install lower and upper
plenum on ROPS (WP 0504).
10. Install crankcase guard
(WP 0374).
11. Troubleshooting complete.
0096-5
