TM 5-3805-296-23-2
0080
Table 1. 1292 Transmission Hold Push Switch Diagnostic Codes.
0080
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
NOTE
1292-03 Gear Hold Switch
Voltage Above Normal
Always inspect harness connectors that are involved in the circuit. Poor
connections can often be the cause of a problem in an electrical circuit.
Verify that all connections in the circuit are clean and secure and that all
connections are in good condition. If a problem with the connection is
found, correct the problem and verify that this malfunction or diagnostic
code is active before performing this procedure.
Perform open or short-circuit test at each harness connection to identify
the correct harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
DIAGNOSTIC CODE SET CONDITION
Transmission/Chassis ECM Detects Conflicting Input on XMSN Gear Hold (N/O)
Switch Circuit R758 and XMSN Gear Hold (N/C) Switch Circuit R759.
POSSIBLE CAUSE
Fuse Panel Wiring Harness High Resistance, Open, or Shorted.
Main Cab Wiring Harness High Resistance, Open, or Shorted.
Implement Control Joystick.
Transmission/Chassis ECM.
Test Step 1. Inspect Implement
Control Joystick Assembly.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Inspect implement control joystick
Joystick Assembly OK Proceed to
assembly for damage (WP 0503).
step 3.
Joystick Assembly Damaged
Replace implement control joystick
(WP 0503).
Proceed to Test Step 12.
3. Press and release gear hold
Button Operates Properly Proceed
button several times
to Test Step 2.
(TM 5-3805-296-10).
Button Fails to Operate Properly
Replace implement control joystick
(WP 0503).
Proceed to Test Step 12.