TM 5-3805-296-23-2
0080
Table 1. 1292 Transmission Hold Push Switch Diagnostic Codes Continued.
080
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
3. Using digital multimeter
1292-03 Gear Hold Switch
Continuity Replace main cab wiring
(WP 0540), test for continuity
Voltage Above Normal
harness (WP 0505).
between connector W-C8 terminal
Continued
Proceed to Test Step 12.
50 (WP 0012, Figure 282) and all
No Continuity Proceed to step 4.
other terminals in connector W-C8
(WP 0012, Figure 282).
4. Using digital multimeter
Continuity Replace main cab wiring
(WP 0540), test for continuity
harness (WP 0505).
between connector W-C12
Proceed to Test Step 12.
terminal 37 (WP 0012, Figure 88)
No Continuity Proceed to step 5.
and all other terminals in
connector W-C12
(WP 0012, Figure 88).
5. Using digital multimeter
Continuity Replace main cab wiring
(WP 0540), test for continuity
harness (WP 0505).
between connector W-C12
Proceed to Test Step 12.
terminal 37 (WP 0012, Figure 88)
No Continuity Replace transmission/
and all terminals in connector
chassis ECM (WP 0495).
W-C13 (WP 0012, Figure 89).
Proceed to Test Step 12.
Test Step 5. Test Fuse Panel Wiring
Harness for High Resistance or
Open.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Connect jumper wire between
terminal 5 and terminal 6
of connector CG-C14
(WP 0012, Figure 302).
3. Disconnect connector CG-C1
(WP 0012, Figure 283)
from connector W-C8
(WP 0012, Figure 282).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 6.
between connector CG-C1
Resistance Greater Than 5.0 Ohms
terminal 49 and terminal 50
Replace fuse panel wiring harness
(WP 0012, Figure 283).
(WP 0515).
Proceed to Test Step 12.
0080-4
