TM 5-3805-296-23-2
0076
Table 1. 1281 Bowl Control Position Sensor Diagnostic Codes Continued.
076
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 2. Inspect Implement
1281-08 Bowl Lever Position
Control Joystick Assembly.
Sensor Abnormal Signal
1. Turn ignition switch and battery
Continued
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Remove right trim panels from
ROPS (WP 0494).
3. Disconnect connector CG-C15
(WP 0012, Figure 301) from
implement control joystick
connector (WP 0012, Figure 300).
4. Inspect implement control joystick
Joystick Assembly OK Proceed to
assembly for damage (WP 0503).
step 5.
Joystick Assembly Damaged
Replace implement control joystick
(WP 0503).
Proceed to Test Step 11.
5. Inspect connector CG-C15
Connector CG-C15 Damaged -
(WP 0012, Figure 301) for damage
Replace fuse panel wiring harness
IAW Electrical General
(WP 0515).
Maintenance Procedures
Proceed to Test Step 11.
(WP 0540).
No Problem Found - Proceed to Test
Step 3.
Test Step 3. Test Bowl Lever Sensor
Circuit, Battery + Circuit, and Ground
Circuit Function.
1. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
2. Using digital multimeter
Voltage 4.5 to 5.5 V Proceed to
(WP 0540), test for voltage
step 3.
between connector CG-C15
Voltage Less Than 4.5 V Proceed to
terminal 5 and terminal 2
Test Step 4.
(WP 0012, Figure 301).
3. Using digital multimeter
Voltage 18 to 25 V Proceed to Test
(WP 0540), test for voltage
Step 6.
between connector CG-C15
Voltage Less Than 18 V Proceed to
terminal 1 (WP 0012, Figure 301)
Test Step 10.
and ground.
0076-11