TM 5-3805-296-23-2
0076
Table 1. 1281 Bowl Control Position Sensor Diagnostic Codes Continued.
076
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
4. Using digital multimeter
1281-03 Bowl Lever Position
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Sensor Voltage Above
Replace main cab wiring harness
between connector CG-C1
Normal Continued
(WP 0505).
terminal 1 and terminal 67
Proceed to Test Step 9.
(WP 0012, Figure 283).
Resistance Greater Than 5.0 Ohms
Replace fuse panel wiring harness
(WP 0515).
Proceed to Test Step 9.
Test Step 9. Verify Malfunction is
Resolved.
1. Ensure all harness connectors are
connected.
2. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
3. At MSD, check for active
1281-3 Bowl Lever Position Sensor
Voltage Above Normal Becomes
diagnostic codes (WP 0008).
Inactive Proceed to step 4.
1281-3 Bowl Lever Position Sensor
Voltage Above Normal Remains
Active Repeat troubleshooting from
the beginning.
4. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
5. Install right trim panels on ROPS
(WP 0494).
6. Troubleshooting complete.
0076-6