TM 5-3805-296-23-2
0075
Table 1. 1280 Ejector Reverse Proportional Solenoid Diagnostic Codes Continued.
075
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
7. Install cover (Figure 5, Item 3), four
1280-05 Ejector Reverse
washers (Figure 5, Item 1), and
Solenoid Current Below
bolts (Figure 5, Item 2) on
Normal Continued
machine.
8. Install hydraulic tube clamp
(Figure 4, Item 4), two washers
(Figure 4, Item 2), and bolts
(Figure 4, Item 3) on mounting
boss (Figure 4, Item 1) and
hydraulic tube (Figure 4, Item 5).
9. Troubleshooting complete.
NOTE
1280-06 Ejector Reverse
Always inspect harness connectors that are involved in the circuit. Poor
Normal
connections can often be the cause of a problem in an electrical circuit.
Verify that all connections in the circuit are clean and secure and that all
connections are in good condition. If a problem with the connection is
found, correct the problem and verify that this malfunction or diagnostic
code is active before performing this procedure.
Perform open or short-circuit test at each harness connection to identify
the correct harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
DIAGNOSTIC CODE SET CONDITION
Transmission/Chassis ECM Detects Above Normal Current on Ejector Reverse
Solenoid Circuit R714.
POSSIBLE CAUSE
Implement Wiring Harness Shorted.
Draft Frame and Bowl Side Wiring Harness Shorted.
Hitch Wiring Harness Shorted.
Main Cab Wiring Harness Shorted.
Ejector Reverse Solenoid.
Transmission/Chassis ECM.
0075-14