TM 5-3805-296-23-1
0060
Table 1. 0585 Transmission Speed Sensor Diagnostic Code Continued.
060
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
0585-02 Speed Sensor 1
5. Using digital multimeter
Continuity Replace main cab wiring
Incorrect Signal Continued
(WP 0540), test for continuity
harness (WP 0505).
between connector W-C12
Proceed to Test Step 22.
terminal 65 (WP 0012, Figure 88)
No Continuity Replace transmission/
and all terminals in connector
chassis ECM (WP 0495).
W-C13 (WP 0012, Figure 89).
Proceed to Test Step 22.
Test Step 9. Test Transmission
Speed Sensor A Resistance.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Using digital multimeter
Resistance 600 to 1800 Ohms
(WP 0540), measure resistance
Replace transmission/chassis ECM
between transmission speed
(WP 0495).
sensor A connector terminal 1 and
Proceed to Test Step 22.
terminal 2 (WP 0012, Figure 115).
Resistance Less Than 600 Ohms
Replace transmission speed sensor A
(WP 0288).
Proceed to Test Step 22.
Resistance Greater Than 1800 Ohms
Replace transmission speed sensor A
(WP 0288).
Proceed to Test Step 22.
Test Step 10. Test for Shorted
Transmission Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector A-C1
(WP 0012, Figure 106)
from connector J-C3
(WP 0012, Figure 101).
3. Using digital multimeter
Continuity Replace transmission
(WP 0540), test for continuity
wiring harness (WP 0266).
between connector A-C1
Proceed to Test Step 22.
terminal 34 (WP 0012, Figure 106)
No Continuity Proceed to step 4.
and all other terminals
in connector A-C1
(WP 0012, Figure 106).
4. Using digital multimeter
Continuity Replace transmission
(WP 0540), test for continuity
wiring harness (WP 0266).
between connector A-C1
Proceed to Test Step 22.
terminal 34 (WP 0012, Figure 106)
No Continuity Proceed to Test
and ground.
Step 11.
0060-7
