TM 5-3805-296-23-1
0060
Table 1. 0585 Transmission Speed Sensor Diagnostic Code Continued.
060
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
0585-02 Speed Sensor 1
2. Using digital multimeter
Resistance 5.0 Ohms or Less
Incorrect Signal Continued
(WP 0540), measure resistance
Proceed to Test Step 18.
between connector A-C1
Resistance Greater Than 5.0 Ohms
terminal 24 and terminal 34
Replace transmission wiring harness
(WP 0012, Figure 106).
(WP 0266).
Proceed to Test Step 22.
Test Step 18. Test for Shorted
Chassis Wiring Harness.
1. Remove jumper wire from
terminal 1 and terminal 2 of
connector A-C13
(WP 0012, Figure 116).
2. Disconnect connector J-C8
(WP 0012, Figure 100)
from connector W-C1
(WP 0012, Figure 99).
3. Using digital multimeter
Continuity Replace chassis wiring
(WP 0540), test for continuity
harness (WP 0305).
between connector J-C3
Proceed to Test Step 22.
terminal 24 (WP 0012, Figure 101)
No Continuity Proceed to step 4.
and all other terminals
in connector J-C3
(WP 0012, Figure 101).
4. Using digital multimeter
Continuity Replace chassis wiring
(WP 0540), test for continuity
harness (WP 0305).
between connector J-C8 terminal 9
Proceed to Test Step 22.
(WP 0012, Figure 100) and all
No Continuity Proceed to step 5.
other terminals in connector J-C8
(WP 0012, Figure 100).
5. Using digital multimeter
Continuity Replace chassis wiring
(WP 0540), test for continuity
harness (WP 0305).
between connector J-C8 terminal 9
Proceed to Test Step 22.
(WP 0012, Figure 100) and
No Continuity Proceed to Test
ground.
Step 19.
Test Step 19. Test Chassis Wiring
Harness for High Resistance or
Open.
1. Connect jumper wire between
terminal 24 and terminal 34
of connector J-C3
(WP 0012, Figure 101).
2. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 20.
between connector J-C8
Resistance Greater Than 5.0 Ohms
terminal 8 and terminal 9
Replace chassis wiring harness
(WP 0012, Figure 100).
(WP 0305).
Proceed to Test Step 22.
0060-11
