TM 5-3805-296-23-1
0060
Table 1. 0585 Transmission Speed Sensor Diagnostic Code Continued.
060
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
0585-02 Speed Sensor 1
Test Step 2. Test Voltage to
Incorrect Signal Continued Transmission Speed Sensor A.
1. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
2. Using digital multimeter
Voltage Greater Than 0.5 V Proceed
(WP 0540), test for voltage
to Test Step 3.
between connector A-C13
Voltage 0.2 to 0.5 V Proceed to
terminal 1 (WP 0012, Figure 116)
step 3.
and ground.
Voltage Less Than 0.2 V Proceed to
Test Step 10.
3. Using digital multimeter
Voltage Greater Than 0.5 V Proceed
(WP 0540), test for voltage
to Test Step 6.
between connector A-C13
Voltage 0.2 to 0.5 V Proceed to Test
terminal 2 (WP 0012, Figure 116)
Step 9.
and ground.
Voltage Less Than 0.2 V Proceed to
Test Step 16.
Test Step 3. Test for Shorted
Transmission Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector A-C1
(WP 0012, Figure 106) from
connector J-C3
(WP 0012, Figure 101).
3. Using digital multimeter
Continuity Replace transmission
(WP 0540), test for continuity
wiring harness (WP 0266).
between connector A-C1
Proceed to Test Step 22.
terminal 34 (WP 0012, Figure 106)
No Continuity Proceed to Test
and all other terminals
Step 4.
in connector A-C1
(WP 0012, Figure 106).
Test Step 4. Test for Shorted Chassis
Wiring Harness.
1. Disconnect connector J-C8
(WP 0012, Figure 100) from
connector W-C1
(WP 0012, Figure 99).
2. Using digital multimeter
Continuity Replace chassis wiring
(WP 0540), test for continuity
harness (WP 0305).
between connector J-C3
Proceed to Test Step 22.
terminal 34 (WP 0012, Figure 101)
No Continuity Proceed to step 3.
and all other terminals
in connector J-C3
(WP 0012, Figure 101).
0060-4