TM 5-3805-296-23-1
0040
Table 1. 1785 Intake Manifold Pressure Sensor Diagnostic Codes Continued.
040
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
3. Remove four bolts
1785-03 Intake Manifold
(Figure 1, Item 1), washers
Pressure Sensor Voltage
(Figure 1, Item 2), bushings
Above Normal Continued
(Figure 1, Item 3), and splash
shield (Figure 1, Item 4) from
machine.
Figure 1. Splash Shield and Retaining Hardware.
0040
4. Connect jumper wire between
terminal 1 and terminal 2
of connector CM-C7
(WP 0012, Figure 22).
5. Disconnect the following:
a. Connector AW-C1
(WP 0012, Figure 36) from fuel
pressure sensor connector
(WP 0012, Figure 35).
b. Connector CM-C9
(WP 0012, Figure 26) from oil
pressure sensor connector
(WP 0012, Figure 25).
c.
Connector CM-C4
(WP 0012, Figure 16) from
atmospheric pressure
sensor connector
(WP 0012, Figure 15).
d. Connector CM-C1 (WP 0012,
Figure 30) from engine ECM.