TM 5-3805-296-23-1
0036
Table 1. 0549 Throttle Lock Diagnostic Code Continued.
036
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 16. Test Fuse Panel Wiring
0549-02 Throttle Lock
Harness for High Resistance or
Enable Switch Erratic,
Open.
Intermittent, or Incorrect
1. Turn ignition switch and battery
Continued
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Disconnect connector CG-C1
(WP 0012, Figure 283)
from connector W-C8
(WP 0012, Figure 282).
3. Connect jumper wire between
terminal 1 and terminal 2
of connector CG-C7
(WP 0012, Figure 307).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 17.
between connector CG-C1
Resistance Greater Than 5.0 Ohms
terminal 64 and terminal 65
Replace fuse panel wiring harness
(WP 0012, Figure 283).
(WP 0515).
Proceed to Test Step 19.
Test Step 17. Test Main Cab Wiring
Harness for High Resistance or
Open.
1. Remove jumper wire from
terminal 1 and terminal 2
of connector CG-C7
(WP 0012, Figure 307).
2. Connect jumper wire between
terminal 64 and terminal 65
of connector W-C8
(WP 0012, Figure 282).
3. Disconnect connector W-C16
(WP 0012, Figure 87)
from connector CL-C3
4. (WP 0012, Figure 86).
5. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 18.
between connector W-C16
Resistance Greater Than 5.0 Ohms
terminal 5 and terminal 22
Replace main cab wiring harness
(WP 0012, Figure 87).
(WP 0505).
Proceed to Test Step 19.
0036-13