TM 5-3805-296-23-1
0036
Table 1. 0549 Throttle Lock Diagnostic Code Continued.
036
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
2. On MSD, select Shutdown and
0549-02 Throttle Lock
Switch Status Changes Each Time
Throttle Lock (Figure 2, Item 1).
Enable Switch Erratic,
Jumper Wire is Connected and
View Throttle Lock Switch status
Intermittent, or Incorrect
Disconnected Replace throttle lock
(Figure 2, Item 2) while performing
Continued
switch (WP 0511).
the following:
Proceed to Test Step 19.
a. Connect jumper wire between
Switch Status Fails to Change Each
terminal 2 and terminal 1 of
Time Jumper Wire is Connected and
connector CG-C7
Disconnected Replace engine ECM
(WP 0012, Figure 307).
(WP 0252).
Proceed to Test Step 19.
b. Remove jumper wire from
terminal 2 and terminal 1
of connector CG-C7
(WP 0012, Figure 307).
c.
Connect jumper wire between
terminal 2 and terminal 3
of connector CG-C7
(WP 0012, Figure 307).
d. Remove jumper wire from
terminal 2 and terminal 3
of connector CG-C7
(WP 0012, Figure 307).
0036-4