10.
Remove gang clamp from the main frame. Attach the gang assemblies to the main frame.
Secure the with clamp plates and 7/8" diameter bolts. Convex end of the gang faces to the left on the front gang
and to the right on the rear gang.
11.
Tighten bolts snug but not tight. For proper placement of the gang frame on the main frame, refer to the chart
and drawing at the end of these instructions. Dimension "A" is measured from the outside of the main frame,
along the center line of the gang frame to the inside of the "U" bolt.
12.
Check and tighten all bolts. Be sure all cotter pins are properly spread and all pins in place. Check the gangs to
see that they rotate freely.
13.
Be sure that the harrow is properly lubricated.
14.
Adjust the harrow for front to rear leveling.
15.
The tongue jack should be mounted on top of the pull tongue when using the harrow to prevent damage and to
secure the gang bolt wrench in place.
19
