Amco F41 Decals
Ref. No.
Part No.
Description
No. Req'd
1
11465
DECAL - AMCCO.................................. 3
2
11741
DECAL - Warning ................................ 1
3
11716
DECAL - Maintenance .......................... 1
MAINTENANCE INSTRUCTIONS
1.
Keep all bolts tight. Check after first 50 hours or
one week's operation.. Visually inspect all bolts daily.
2.
Keep wheel bearings properly adjusted. Clean
and repack each season or every 300 hours. Replace all
worn or damaged parts when repairing.
3.
Keep gang bolts tight! Tighten after first day's
operation Do not run with loose disk blades. If gang bolts
have been operated in a loose condition, retighten, then
tighten again after 30 minutes use, again after 4 to 5
hours, and again after 8 to 10 hours.
4.
Grease gang bearings daily with a hand grease
gun and a good grade of clean, number 2, lithium soap
base grease. Always wipe fittings clean before greasing.
Apply grease until. old or dirty grease is purged from
bearings. Avoid high-pressure greasing.
5.
Inspect for damaged or misaligned parts if gangs
to not turn smoothly by hand. Bearings will fall
prematurely if operated with misaligned or damaged gang
parts. If a gang is operated for one or more hours
following a bearing failure replace all bearings on the
gang.
11716
Refer to the operator's manual for other important maintenance instructions.
14
