TM
3-4240-309-20&P
ACTION
ITEM
LOCATION
Gas-Particulate
Filter unit stand
1.
Place housing unit (17) in lower half of rear
filter unit stand (19).
Place upper half of rear filter unit stand (16)
2.
over housing unit (17), and install and tighten
two screws (13), washer (14), and nuts (15).
Place front filter unit stand (18) against housing
3.
unit (17), and install but do not tighten eight
screws (11) and washers (12) through front
filter unit stand (18) into housing unit (17).
Install but do not tighten screws (6 and 7) and
4.
washers (8 and 9) in two lower reinforcing
rods (10).
Install and tighten screws (1 and 3) and
5.
washers (2 and 4) on upper reinforcing rods
(5). Tighten screws (11, 7, and 6).
Install inlet collar (p. 2-100).
6.
Install inlet airduct hose (p. 2-105).
7.
Install inlet cap (p. 2-103).
8.
Install exhaust sleeve (p. 2-102).
9.
10. Install power distribution unit (p. 2-95).
11. Install M5 static frequency converter (p. 2-104).
12. Turn on power source.
13. Set POWER switch (1) on compartment control
module to ON.
14. Perform functional check (p. 2-3).
2-99