TM 5-4930-244-14
(5)
Adjustment.
(a)
Move the locknuts (10) to the end of the control rod (12).
(b)
Adjust the idling speed to 1200v/min by screwing in the adjusting nut (11) to increase the speed or
out to decrease it
NOTE
If the minimum speed required is above the idling speed turn the adjusting nut (11)
toward the holding bracket (8) until the required speed is attained and lock the
adjusting nut (11) in position
(c)
Lock the adjusting nut (11) with the two locknuts (10).
(d)
Slacken the adjust nut (14).
(e)
Move the control rod (12) in the direction of the arrow so that the adjust nut (15) is hard against the
upper throttle bracket (3).
(f)
Maintain the adjust nut (14) hard against the upper throttle bracket (3) and adjust the full speed by
turning the adjust nut (14) counterclockwise to increase the speed or clockwise to decrease it. The
speed should be set at 8% above the rated speed.
(g)
Position the adjust nut (14) against the upper throttle bracket (3) and tighten the adjust nut (15).
(h)
Fit and adjust the holding throttle assembly (6) so that it is capable of moving the control rod (12) from
the minimum speed to the full speed position.
5-49