TM 5-4930-244-14
Figure 5-19. Stop/Run Lever
j.
Engine Air Cowling.
(1)
Removal. (Refer to Figure 5-20).
(a)
Remove nut (1), washer (2) and lifting eye (3).
(b)
Remove nut (4), washer (5) from top of engine air cowling (6).
(c)
Remove two cap screws (7), two washers (8) from side of engine air cowling (6).
(d)
Remove engine air cowling (6) and washers (11) from studs (9) on cylinder head (10). Remove
captive nuts (13) from cowling (6)
(e)
Remove stud (9) from cylinder head (10).
(2)
Repair.
(a)
Inspect all parts for damage, cracks, distortion and other damage. Replace parts as needed
(b)
Clean threads (12) in cylinder head (10) with thread-cutting tap.
(3)
Installation.
(a)
Install studs (9) into cylinder head (10) and install two washers (11) on studs (9).
(b)
Position two captive nuts (13) on cowling (6). Position engine air cowling onto studs (9).
(c)
Install two cap screws (7) and two washers (8) on side of engine air cowling (6).
(d)
Install washer (5) and nut (4) onto stud (9). Tighten.
(e)
Install lifting eye (3), washer (2) and nut (1) onto stud (9). Tighten.
5-53