4-117. BRUSH REPLACEMENT.
This task covers:
Tool Kit, General Mechanic's: Automotive
TM or Para
Broom hood removed.
This task may also be used to reverse the entire brush assembly as one piece to increase the lift
of the brush.
Release spring tension on hydraulic
cylinder to allow brush to drop.
Damage to equipment may occur.
Refer to para 4-119 to back off nut and
release tension on hydraulic cylinder.
Bracket is located on right side only.
Remove two locknuts (1), two washers (2),
two screws (3), and bracket (4) using a
ratchet and 3/4 in. socket.
Repeat step (2) for opposite side.
Remove brush assembly (5) from brush
Loosen setscrew (7) using a 15/16 in. Hex