TM 5-3825-230-14&P
4-118.
HYDRAULIC CORE/BRUSH SET REPLACEMENT (CONT)
b.
Installation.
(1)
Install disk (3), four lockwashers (2), and
four screws (1) using a ratchet and 1/2 in.
socket.
CAUTION
Use a pallet or suitable cribbing to
support
core
upright
during
assembly to prevent damage to
brush.
(2)
Stand core (6) upright, on disc (3).
NOTE
A ladder is required to install wafers
and spacers on core.
Plastic bristle wafers are located at both
ends.
(3)
Alternately install plastic bristle wafers (4)
and spacers (5) over full length of core (6).
(4)
Install remaining disc (3), four lockwashers
(2), and four screws (1) on upper end of
core (6) using a ratchet and 1/2 in. socket.
WARNING
Stand clear of brush assembly during lowering procedure. Personal injury may result from
falling brush.
(5)
Lower brush assembly to horizontal position.
NOTE
Follow-on maintenance: Install brush assembly (para 4-117)
END OF TASK
4-212