TM 5-3825-230-14&P
4-119.
HYDRAULIC CYLINDER REPLACEMENT (CONT).
(5)
Remove cotter pins (8) using pliers and drive out pin (9) using a drift and ball peen hammer.
(6)
Remove hydraulic cylinder (10).
(7)
Remove two springs (2), and four washers (11).
b.
Installation.
(1)
Install hydraulic cylinder (10).
(2)
Install pin (9), and cotter pin (8) using pliers and ball peen hammer.
(3)
Install pin (7), and install cotter pins (6) using pliers and ball peen hammer.
(4)
Install two springs (2), and four washers (11) on balance rod assemblies (5).
(5)
Install balance rod assemblies (5) with washers (11), and springs (2).
(6)
Install pin (4), and cotter pins (3) using pliers.
(7)
Tighten nuts (1) using a 1-1/8 in. open end wrench.
NOTE
Follow-on maintenance:
Install brush frame (para 4-114)
Adjust broom pattern (para 4-111)
END OF TASK
4-214