TM 9-4940-568-34
6-26
6-6.
SWING DRIVE ASSEMBLY REPAIR (Continued)
(2) Position shaft (38) in press.
(3) Pack bearing (42) with grease and
press bearing onto shaft (38).
(4) Remove shaft (38) from press.
(5) Install shaft (38) in hub (36).
(6) Pack bearing (43) with grease and
install bearing on shaft (38).
(7) Install lockwasher (37) and nut (39) on
shaft (38).
(8) Tighten nut (39) until shaft (38) starts to
turn.
(9) Position shaft (38) in soft jaw vise.
(10) Hold shaft (38) and tighten nut (39) until
one tine on lockwasher (37) alines with
slot in nut.
(11) Bend tine of lockwasher (37) up in slot
of nut (39).
(12) Remove shaft (38) from vise.
(13) Turn hub (36) over and install seal (41)
and gear (40) on hub.
(14) Apply adhesive on mating surface of
hub (36) and install preformed packing
(35) on hub.
(15) Aline matchmarks and install ring gear
(34) on hub (36).