2
3
4
1
6
7
MOUNTING
HOLE
TM 9-4940-568-20
8-48
8-17. MAGNETIC SPEED PICKUP SENSOR REPLACEMENT (CONT).
b. Installation.
(1)
Remove cover (6) and install engine
turnover tool (7).
(2)
Bar engine until a gear tooth on the flywheel
lines up in center of the mounting hole.
(3)
Thread the magnetic pickup (4) in gently
until it just touches the gear tooth.
(4)
Back magnetic pickup (4) out one quarter
turn and tighten jamnut (3).
NOTE
Install wires as noted during
removal.
(5)
Install two wires (1) on electronic overspeed
module (2).
c.
Follow-On Maintenance:
Connect batteries, (TM 9-4940-568-10).
Start generator and check for leaks,
(TM 9-4940-568-10).
END OF TASK