TM 9-4940-568-10
2-150
2-32. GROUNDING PROCEDURE (CONT).
b.
Grounding Rod Removal.
1 FT
MOISTURE LEVEL
8 FT
2
5
3
1
4
Electric power generating equipment must be grounded as a safety precaution. Stray
electrical current can injure or kill personnel and damage the equipment.
Ensure MASTER DISCONNECT switch is in the OFF position. Failure to comply may
result in serious injury or death to personnel.
(1)
Remove wingnut (3) and static cable (4) from grounding terminal (5) on corner of FRS and install
wingnut.
(2)
Remove grounding rod (2) from ground.
NOTE
Two piece grounding rod is stowed in tool rack on rear wall inside shelter.
(3)
Disassemble and stow grounding rod (2) on generator door (1) and close generator door.
(4)
If further grounding procedures are necessary, refer to FM 5-424.
