TM 9-2330-324-14&P
0052
00-4
AXLE REPLACEMENT—Continued
0052
00
INSPECTION AND REPAIR
1.
Check threads of axle spindle for wear, crossed threads, or other damage.
2.
Using fine file, remove burrs, or hand chase threads if necessary.
3.
Check axle spindle for bend. Indications of a bent axle spindle are binding bearings, which cannot
be adjusted properly, and extremely uneven wear of brake linings. Replace axle if spindle is
defective.
4.
Check for damaged paint and repaint where necessary.
INSTALLATION
WARNING
Axle (2) is heavy and awkward to handle. Use caution, provide adequate
support, and use assistance during installation. Failure to follow this
warning may result in serious injury.
1.
Position axle (2) on dolly.
2.
Place support under axle (2).
3.
Carefully raise and position axle (2) on springs (21). Support axle at both ends.
4.
Install four U-bolts (22), two plates (19), and eight new locknuts (20) on axle (2) and springs (21).
5.
Tighten nuts (20) to a torque of 223 lb-ft (302 N•m).
21
20
19
2
22
