TM 9-2330-324-14&P
0030
00-1
WIRING HARNESS AND CABLE ASSEMBLY REPAIR
0030
00
THIS WP COVERS:
Identification Band Replacement, Terminal Replacement, Male Connector Repair, Female Connector
Repair
INITIAL SETUP:
Maintenance Level
Tools and Special Tools
Organizational
Electric Etcher
Terminal Kit
Materials/Parts
Tool Kit, Electrical Connector
Contacts (as required)
Tool Kit, General Mechanic’s
Identification Bands (as required)
Terminals (as required)
Equipment Conditions
Intervehicular Cable Assembly Disconnected
From Towing Vehicle (WP 0007 00)
IDENTIFICATION BAND REPLACEMENT
1.
Remove identification band (2) from wire lead (1) and discard.
2.
Mark new identification band (2) with proper identification number.
3.
Position new identification band (2) on wire lead (1) and bend tabs over wire lead.
2
1
TERMINAL REPLACEMENT
1.
Cut terminal (3) off wire lead (4) and discard terminal.
2.
Strip insulation off wire lead (4) equal to depth of new terminal (3).
3.
Position new terminal (3) on wire lead (4). Crimp terminal.
4
3
