TM 9-2330-238-14
2-13. EXPANDING
ANDRETRACTING
VAN BODY (M313) (Con’t).
(3)
Using ratchet wrench, release tension on both retractable
beam drive shafts (2).
(4)
Retract sliding bolt (12) on end panel door (1) from latch (17).
(5)
Remove four hook holders (6) on end panel doors (1) from clips (5). Open end panel doors and use
hook holders to keep end panel doors open at 120°.
(6)
Raise hinged roof (14) until it clears three swivel hooks (10). Turn swivel hooks until they are flush with
side wall (8), then lower hinged roof.
(7)
Standing clear on ground, raise hinged floor (16) into vertical position.
Pull hinged roof (14) partially
out to clear hinged floor. Close hinged roof against hinged floor and engage
lock (13) on hinged roof.
(8)
Repeat steps 5 through 7 for opposite
side wall (8).
(9)
Close four end panel doors (1) against side wall (8) and place hook holders
(6) in clips (5).
(10)
Using ratchet wrench and hexagon socket on two ratchets, turn retractable
beam drive shaft (2) until
side walls (8) are fully retracted
against van body.
(11)
Using lock wrench on four side locks (9), engage four side locks ¼ turn clockwise.
2-17
