NOTE
TM 9-2330-238-14
2-13. EXPANDING
AND RETRACTING
VAN BODY (M313) (Con’t).
(5)
Release
lock (13) on outside
of hinged
roof (14), and pull partially
outward.
Standing
clear on
ground, pull on grab handle (15) attached to lower hinged floor (16). Ensure that floor panel area is clear. Move to inside
van and push hinged roof and lower hinged floor outward at same time.
(6)
Raise up hinged roof (14) until it clears three swivel hooks (10). Turn swivel hooks at 90° to sidewall
(8) and lower hinged
roof to rest on swivel hooks.
It is necessary
to raise hinged roof to obtain snug fit between
doors and seals.
(7)
Release four hook holders (6) from end panel doors (1) and place hook holders
in clips (5). Swing
end panel doors inward until they contact
hinged floor (16) and roof seals.
(8)
Using large end of lock wrench, push sliding bolt (12) on end panel door (1) in latch (17). Ensure that
sliding
bolt is fully extended.
(9)
Switch
retractable
beam drive shaft (2) to closed
position
and place
crank arm in a horizontal
position.
Turn ratchet wrench while
slightly
lifting hinged
roof (14) at end panel doors
(1) to ensure proper
seal
alinement.
(10)
Repeat steps 5 through 9 for opposite
side of van.
2-14
