TM 9-2330-238-14
2-13. EXPANDING
AND RETRACTING
VAN BODY (M313) (Con’t).
(11)
(12)
to ensure a tight
Inside van, jump on both hinged floors (16) to ensure that no binding
of alinement
pins exists.
Move outside of van and apply full weight on ratchet wrench to both retractable
beam drive shafts (2)
seal.
(13)
From inside van, engage six clamp locks (11) on swivel hooks (10) and draw side walls (8), end
panel doors (1), and ceiling panels tight against seals. Start with center clamp lock on each side.
(14)
Ensure that sliding bolt (12) on each end panel door (1) is fully extended
into latch (17).
(15)
Engage four side wall corner locks (4) in extension
rods (7).
TA701919
2-15
