TM 9-2330-238-14
5-11. LANDING
GEAR MAINTENANCE
(EARLY MODEL)
(Con’t).
27.
Remove two retaining rings (61) and lubrication
fitting (60) from pin (62). Discard retaining rings and lubrication
fittings.
NOTE
Note position of pin for installation.
Lubrication fitting end of pin is roadside.
28.
Drive out pin (62) and remove roller (64) with two bearing sleeves
(63) assembled.
29.
Remove four capscrews
(56) and Iockwashers
(57) from two remote control
levers (53) and roller arms (5).
Discard
Iockwashers.
30.
Work two remote control
levers (53) away from roller arms (5) and past four woodruff
keys (52).
31.
Remove four woodruff
keys (52) from cross shaft (8).
32.
Remove two roller arms (5) from cross shaft (8).
33.
Remove bearing block (7) with two assembled
sleeve bearings
(54) from cross shaft (8). Remove lubrication
fittings
(55) from bearing
block and discard.
34.
Remove capscrew
(59) and nut (58) from each roller arm (5).
35.
If damaged,
remove two sleeve bearings
(54) from bearing block (7) and two sleeve bearings
(63) from roller
(64).
1.
If removed,
install two sleeve bearings
(63) in roller (64) and two sleeve bearings
(54) in bearing block (7).
2.
Install new lubrication
fitting (55) in bearing block (7). Install bearing block on cross shaft (8). Install two roller
arms (5) on cross shaft, one on each side of bearing block.
TA702072
5-24
