TM 5-4930-244-14
(4)
Clean off corrosion with wire brush, then repaint in accordance with TM 43-0139.
(5)
Fix dents as needed. (Reference. FM 43-2).
(6)
Weld cracks as needed. (Reference. TM 9-237).
b.
Installation.
(1)
Position two person at each corner of lube tank (1) and lift and place lube tank (1) onto skid (3), lining up holes on
skid (3).
NOTE
Steps (2) through (4) apply to all 3 lube compartments.
(2)
Install gasket (35) and gasket retainer (34) onto manhole lid (30).
(3)
Install formed washer (32) and new locknut (31) onto bolt (33). Tighten.
(4)
Close manhole lid (30), securing it with spring latch (28).
(5)
Install eight bolts (26) and washers (25) through mount brackets (27) on lube tank (1) and skid (3). Install and
tighten eight locknuts (24).
(6)
Install exhaust manifold (18) to manifold bracket (23) by installing two bolts (21) and lockwashers (22).
(7)
Install 5" heater duct (20) to exhaust manifold (18) and heater plenum (19). Tighten clamps (17) at exhaust
manifold (18) and heater plenum (19).
(8)
Connect exhaust diverter (8) to exhaust diverter bracket (13) by installing u-bolt (12) two nuts (10) and two
lockwashers (11).
(9)
Connect loose end of interflex hose (15) to tube (16) on rear of lube tank (1). Tighten outer worm gear hose
clamp (14).
(10)
Slide interflex hose (9) onto diverter (8).
(11)
Slide u-clamp (6) around interflex hose (9). Install bracket (5) onto u-clamp (6). Secure bracket (5) by installing
two nuts (4) onto u-clamp (6).
(12)
Slide interflex hose (7) onto tube on lube tank (1) and onto diverter (8).
(13)
Slide two u-clamps (6) around interflex hose (7). Install two brackets (5) onto u-clamps (6). Secure brackets (5)
by installing two nuts (4) onto each u-clamp (6).
NOTE
Wind Teflon Tape ten times around each magnetic plugs (2).
(14)
Replace three plugs (2) into lube tank (1) under bottom of skid (3). Fill lube tank (1) with appropriate lubricants.
5-84
