TM 5-4930-244-14
5-16.
INTERVEHICULAR WIRING HARNESS - REPAIR.
This Task Covers:
a.
Test
b.
Disassembly
c.
Assembly
Initial Setup:
Tools Required
Tool Kit, General Mechanic's: Automotive (Appendix B, Section III, Item 1).
Multimeter (Appendix B, Section III, Item 2).
Equipment Condition
Unit shut down and cool
a.
Test.
Using a multimeter, check for continuity between matching pins on connectors.
b.
Disassembly. (Refer to Figure 5-29.)
(1)
Remove two screws (1) from each connector housing (2).
(2)
Slide connector housing (2), with spring (3) back on cable (4).
(3)
Disconnect individual wires of cable (4) from connector (5).
(4)
Remove connector housing (2) and spring (3) from cable (4). Unscrew spring (3) from connector housing (2).
c.
Assembly.
(1)
Screw spring (3) onto connector housing (2).
(2)
Install cable (4) through spring (3) and connector housing (2).
(3)
Connect individual wires of cable (4) to connections of connector (5), matching color of wires with color indicated
on connector (5).
(4)
Slide connector housing (2) over connector (5) and install two screws (1).
5-88
