TM 5-4930-244-14
4-47. EXHAUST LINE/HOSES - REPLACE.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Tools Required
Tool Kit, General Mechanic's Automotive (Appendix B, Section I, Item 1)
Materials/Parts Required
None.
Equipment Condition
Unit shut down and cool.
WARNING
Do not touch hot exhaust system components with bare hands
Components become hot during operation. Allow them to cool before handling.
a. Removal. (Refer to Figure 4-47).
(1)
Remove four nuts (1) and two, brackets (2) from two u-clamps (3) holding interflex hose (4).
(2)
Remove interflex hose (4) and fiberglass sleeving (5) from muffler assembly (6) and diverter (7).
(3)
Remove four nuts (1) and two brackets (2) from u-clamps (3) holding interflex hose (8).
(4)
Remove interflex hose (8) and fiberglass sleeving (9) from diverter (7) and tube (10) on lube tank (5) Loosen
clamps (11) and disconnect hose (12) at heater plenum (13) and heat inlet (14).
(6)
Loosen two bolts (15) and lockwashers (16) from bracket (17) and remove heat inlet (14), if necessary.
(7)
Loosen four clamps (18) on two remaining ducts (19) leading from heater plenum (13). Remove two ducts (19)
4-147
