TM 54930-244-14
(i)
Remove hose assembly (26) from winterization assembly heater exhaust (27) by loosening clamp (28).
(j)
Loosen clamp (29) from lube tank (12) and remove hose assembly (26).
(k)
Remove six cap screws (30), six washers (31) and six self-locking nuts (32) from belt guard (19). Discard
six self-locking nuts.
(I)
Remove belt guard (19).
(m)
Remove access plate (33) by loosening two thumb screws (34).
(n)
Loosen four bolts (35), one adjustment nut (36) and slide air compressor (37) forward until air compressor
belts (38) can be taken off of flywheel (39) and clutch assembly (25).
(o)
Remove air compressor belts (38).
(2)
Installation.
NOTE
Before tightening air compressor belts, make sure that air compressor flywheel
and clutch assembly are in line with each other. If they are not, see section (3)
below.
(a)
Install new air compressor belts (38) onto clutch assembly (25) and flywheel (39).
(b)
Slide air compressor (37) back until air compressor belts (38) can be depressed about one inch or 1 1/4
inch Tighten adjustment nuts (36).
(c)
Tighten four air compressor bolts (35).
(d)
Replace access plate (33) by tightening thumb screws (34).
(e)
Install belt guard (19) by installing six cap screws (30), six washers (31), and six self-locking nuts (32).
(f)
Install hose (26) to winterization assembly heater exhaust (27) by tightening clamps (28) and to lube tank
(12) by tightening clamp (29).
(g)
Install clutch fork (23) onto clutch assembly (25) by spreading its ends and pushing it onto pins (24).
(h)
Install clutch arm (18) to clutch fork (23) with cap screw (20), washer (21), and self-locking nut (22).
(i)
Install clutch arm (18) to belt guard (19) using cap screw (15), washer (16), and self-locking nut (17).
(j)
Install heat inlet (3) to lube tank (12) using two hex head cap screws (13) and two lock washers (14).
Attach air tubing (42) to quick disconnect at side of belt guard (19).
(k)
Install muffler (7) and gasket (8) to diesel engine exhaust (10) using two lockwashers (6) and two nuts (5).
(I)
Install lube tank duct (1) to winterization assembly heater plenum (27) and heat inlet (11) by tightening two
clamps (4)
4-79
