TM 5-4930-244-14
d. Repair.
(1)
Inspect gauges for discolored or illegible markings, bent or sticking dial pointers and loose, damaged or corroded
connectors Replace defective gauges.
(2)
Check operation of switches The toggle switch must operate positively to each of its positions. Replace defective
toggle switch.
(3)
Inspect all electrical connections Replace components that have loose, corroded or damaged connectors.
(4)
Inspect wiring for defectives. Repair wiring (5) Inspect control panel for cracks, illegible markings and damage.
Replace or repair as needed.
e. Assembly.
(1)
Install on/off switch (27) and on/off plate (63) through rear of control panel (2) and then install jam nut (62) onto
on/off switch (27) and tighten.
(2)
Mount shunt bar (61) to rear of control panel (2) with two machine screws (58) washers (59) and nuts (60), then
tighten.
(3)
Install throttle adjustment knob (10) onto throttle rod (9) Install nut (56) and washer (57) onto throttle rod (9).
(4)
Install throttle rod (9) into side of control panel (2) Install washer (55) and two nuts (54) onto throttle rod.
(5)
Install throttle spring (13) onto throttle rod (9), over washer (55) and two nuts (54) against rear of control panel (2).
(6)
Thread throttle rod (9) into throttle bracket (11).
(7)
Tighten the two rear nuts (54), and front nut (56) on throttle rod (9) until snug against front and rear of control
panel.
(8)
Turn throttle adjustment knob (10) on throttle rod (9) until slack in chain (12) is taken up a little. It is not necessary
to tighten chain (12) much, until installation.
(9)
Install start button (29) and jam nut into back side of control panel (2).
(10)
Install glow plug button (25) and jam nut into back side of control panel (2).
(11)
Install covers (53) onto start button (29) and glow plug button (25).
(12)
Install ammeter (40) into control panel (2) with three screws (51) and three nuts (52).
(13)
Install oil pressure gauge (31) into control panel (2) and onto bracket (50). Secure with two lockwashers (64) and
two nuts (49).
(14)
Install fuel gauge (33) into control panel (2) and onto bracket (50). Secure with lockwashers (64) and two nuts
(49)
4-73
