TM 5-4930-244-14
(12)
Remove positive cable (20) from starter motor, located on air compressor. (Reference para. 4-39.d (2)(h)).
(13)
Pull the three cables (13, 19, 20) forward through the larger grommet (21) at rear of reel cabinet assembly (11)
(14) Remove two screws (22), two lockwashers (23) and drawer stop (24) from battery drawer (12).
(15)
Pull battery drawer (12) completely out of reel cabinet assembly (11) and set it aside.
(16)
Disconnect air-receiver tank drain hose (25) from side of air-receiver tank.
(17)
Disconnect air supply hose (26) from end of air receiver tank (1).
(18)
Remove heater duct at side of reel cabinet by removing two clamps and swinging duct out of the way.
(19)
Remove four self-locking nuts (27), four washers (28) and four bolts (29) from reel cabinet assembly (11) Discard
four self-locking nuts (27).
(20)
Remove reel cabinet assembly (11) from skid (30).
b.
Installation.
(1)
Place reel cabinet assembly (11) onto skid (30).
(2)
Fasten reel cabinet assembly (11) to skid (30) using four new self-locking nuts (27), four bolts (29), and four
washers (28).
(3)
Attach five supply hoses (31) to reel assembly. (Reference para. 4-18).
(4)
Attach drain hose (25) to side of air-receiver tank and tighten Attach air supply hose (26) at end of receiver tank.
(5)
Place battery drawer (12) Into reel cabinet assembly (11).
(6)
Push wire assembly (15) onto thermostat (16) located on left rear side of battery drawer (12).
(7)
Pull wire #5 (17) through larger grommet (21) on back of reel cabinet assembly (11), and connect wire #5 (17) to
positive battery terminal (18).
(8)
Push cable assemblies (13, 19, 20) back through larger grommet (21) at rear of reel cabinet assembly (11).
(9)
Reconnect cable terminal (13) to battery (14) Close battery drawer (12).
(10)
Install drawer stop (24) on right side of battery drawer (12) by installing two screws (22) and two washers (23)
onto battery drawer (12).
(11)
Place accessory/tray drawers (10) into reel cabinet assembly (11).
(12)
Install drawer stop (9) on right side of accessory/tray (10) by installing two screws (7) and two washers (8) onto
accessory/tray (10).
4-53
