TM 5-4930-244-14
c.
Repair.
Inspect all parts for damaged threads, cracks, distortion and other damage. Replace any part that shows obvious
wear or damage.
d.
Assembly. (Refer to Figure 4-15.)
(1)
Install capscrews (11) in reel half (15) and place spacers (12) on capscrews.
(2)
Assemble reel half (14) to reel half (15) and install locking nuts (10).
(3)
Wrap threads of swivel (13) with teflon tape and install swivel in reel.
(4)
Place two washers (9) on reel and install on bracket (16). Install other washer (9) and cotter pin (8).
(5)
Assemble roller (6) to bracket (7) and secure with screws (4) and locking nuts (5).
(6)
Place roller assembly bracket (7) on reel bracket (16) and install capscrews (1), washers (2) and locking
nuts (3)
e.
Installation. (Refer to Figure 4-14.)
(1)
Clean and wrap Teflon tape around threads of male fittings (7).
(2)
Connect male fittings (7) to ends of hose (1).
(3)
Screw male fitting (7) into reel assembly (2).
(4)
Place hose reel assembly (2) onto reel cabinet assembly (6).
(5)
Install four bolts (3), lockwashers (4), and flat washers (5) into top of reel cabinet assembly (2).
NOTE
Do not remove hex reducing nipple from hose assembly.
(6)
Roll hose assembly (1) onto reel assembly (2).
4-49
