TM 5-4930-244-14
4-26. CABINET ASSEMBLY - REPLACE.
This Task Covers:
a.
Removal
b.
Installation
Initial Setup:
Tools Required
Tool Kit, General Mechanic's: Automotive (Appendix B, Section II, Item 1).
Materials Required
Rags, wiping (Appendix E, Section II, Item 1).
Nut, self-locking (Appendix H, Section II, Item 11).
Equipment Condition
Enclosure Removed (para. 4-13).
Unit shut down and cool.
Lube Supply Hoses Disconnected (para. 4-18).
Personnel Required
2
a.
Removal. (Refer to Figure 4-16.)
WARNING
·
Compressed air may cause severe injury or death, If not used properly.
Completely vent air pressure by turning drain levers as indicated below.
(1)
Relieve air from air-receiver tank (1) by turning condensate removal valve handle (2) to "open" position.
(2)
Open ball valve (3) on air-receiver tank (1).
(3)
Open ball valve (4) on gear lube pump.
(4)
Open shut-off valve (5) on air-receiver tank (1).
(5)
Remove lockbar (6) Remove two screws (7), two lockwashers (8) and drawer stop (9) from accessories/tray
drawers (10).
(6)
Pull accessories/tray drawers (10) completely out of reel cabinet assembly (11) and set them aside.
CAUTION
·
Before servicing, disconnect ground cable to prevent damage to the batteries.
·
Do not let ground cable come in contact with positive battery terminal or cable.
(7)
Open battery drawer (12) and disconnect ground cable (13) from battery (14) using a 1/2" box end wrench.
4-50
