TM 5-4930-244-14
4-14. DOORS - REPLACE/REPAIR.
This Task Covers:
a.
Removal
b.
Disassembly
c.
Repair
d.
Assembly
e.
Installation
Initial Setup:
Tools Required
Tool Kit, General Mechanic's: Automotive (Appendix B, Section III, Item 1).
Riveter, Blind, Hand (Appendix B, Section III, Item 2).
Electric Drill, 3/16" drill bit (Appendix B, Section III, Item 2).
Materials/Parts Required
Rivets (Appendix H, Section II, Items 1 and 2).
Locknut (Appendix H, Section II, Item 77).
Equipment Condition
Engine shut down and cool.
Personnel Required
2
NOTE
The following procedures apply to any of the four enclosure doors.
a.
Removal. (Refer to Figure 4-2.)
(1)
Open slam latches (1) on outside of doors (2). Raise door up and fold.
(2)
Unlatch finger bolt latches (3) on inside of doors (2). Let doors hang freely.
(3)
Drill out rivets (4) at top hinge (5) of doors (2), using electric drill with a 3/16" drill bit.
(4)
Remove doors (2) from enclosure (6).
b.
Disassembly.
(1)
Lay door (2) flat on work table. Drill out rivets (4) on lower portion of top hinge (5), removing hinge (5) from
door (2).
(2)
Remove rivets (7) from lower hinge (8), and remove hinge (8) from door (2).
(3)
Drill out door latch rivets (9) and remove door latches (10) from typical two places.
(4)
Remove machine screws (11), washers (23) and locknuts (24) from hooks (12) and remove hooks (12) from
door (2).
(5)
Drill out rivets (13) securing two inner door latches (3) to door (2) and remove from door (2).
(6)
Drill out shutter rivets (21), removing shutter (22) from door (20).
4-14
